If assemble more than one number, attach the desire numbers in order with the connected bracket. (Fig 1)

Insert the power supply & light controller modules one with the wire pin to the left-side of the first number, fasten all modules with the screws provided. Do not over tighten, use hand tools only.(Fig 2)

Select the location of the numbers, mark the position and drill 4 holes of 3/16” diameter and 1”depth. Insert plastic anchors. Drill a feed-through hole right behind location of the end bracket with DC power wire. Feed adapter wire through the hole from inside out, connect together with wire connectors provided. (Fig 3)

Mount the assembled numbers to the house using the 4 screws provided, when certain installation is fully completed, plug the adapter into the indoor AC outlet.

To check if functioning during daytime, select desire multicolored or constant color function mode, both can shift at any time, cover the sensor, the numbers will illuminate. It will turn off when sensor is uncovered. When constant color mode is selected, the illuminate color will change by sequences in next sensor function. (Fig 4)

Note

- For prevent risk of electric shock power adaptor plug indoor outlet only.
- Manufacturer not recommend connect more than five numbers.
- Should additional wire be required, low voltage speaker wire may be used.